Whirlpool Water Heater Igniter Not Working

When trying to light the heater be sure to put the gas valve on the water heater in the pilot position and hold down on the pilot button.

Whirlpool water heater igniter not working.

If you still can t see a spark turn the gas control knob off turn the gas supply valve off and click on more help below. Make sure the wire is connected at the bottom of the push button that makes the igniter spark. Make sure the gas supply valve is turned on. This video provides step by step instructions for replacing the igniter and flame sensor on ao smith gas water heaters.

If the igniter is getting voltage but it doesn t glow this indicates that the igniter is defective and should be replaced. To determine if the igniter is defective first make sure the igniter is getting voltage. The spark is small and the igniter is deep inside the base of the water heater. You may have to dim the room lights to see the spark.

The most common reason for replacing. These newer furnaces do not use a pilot. Step by step instructions on how to replace the thermocouple on a whirlpool water heater. If the status light is not flashing try lighting the pilot using the instructions on the water heater s label.

While continuing to hold down the pilot button press down on the igniter button three or four times. Gas furnaces now come with an igniter that works electronically to light the gas and heat the home. Keep the knob pushed in while repeatedly clicking the spark igniter button. Either you own a rinnai tankless water heater navien ao smith takagi bosch or any other on demand model use this article and get the necessary information on how to deal with the problem ignition failure which is the main reason why users complain about the flame loss water heater not working no hot water and alike.

Some water heaters use an igniter to ignite the gas. When lighting the pilot make sure the knob on the gas control valve is fully pushed in.